A40MX02 datasheet(19/142 Pages) MICROSEMI

19 / 142 page

40MX and 42MX FPGA Families

Re vi s i on 11

1 - 15

JTAG Mode Activation

The JTAG test logic circuit is activated in the Designer software by selecting Tools -> Device Selection.

This brings up the Device Selection dialog box as shown in Figure 1-14. The JTAG test logic circuit can

be enabled by clicking the "Reserve JTAG Pins" check box. Table 1-5 explains the pins' behavior in

either mode.

TRST Pin and TAP Controller Reset

An active reset (TRST) pin is not supported; however, MX devices contain power-on circuitry that resets

the boundary scan circuitry upon power-up. Also, the TMS pin is equipped with an internal pull-up

resistor. This allows the TAP controller to remain in or return to the Test-Logic-Reset state when there is

no input or when a logical 1 is on the TMS pin. To reset the controller, TMS must be HIGH for at least five

TCK cycles.

Boundary Scan Description Language (BSDL) File

Conforming to the IEEE Standard 1149.1 requires that the operation of the various JTAG components be

documented. The BSDL file provides the standard format to describe the JTAG components that can be

used by automatic test equipment software. The file includes the instructions that are supported,

instruction bit pattern, and the boundary-scan chain order. For an in-depth discussion on BSDL files,

please refer to Actel BSDL Files Format Description application note.

BSDL files are grouped into two categories - generic and device-specific. The generic files assign all user

I/Os as inouts. Device-specific files assign user I/Os as inputs, outputs or inouts.

Generic files for MX devices are available on the Microsemi SoC Product Group's website:

http://www.microsemi.com/soc/techdocs/models/bsdl.html.

Figure 1-14 • Device Selection Wizard

Table 1-5 •

Boundary Scan Pin Configuration and Functionality

Reserve JTAG

Checked

Unchecked

TCK

BST input; must be terminated to logical HIGH or LOW to avoid floating

User I/O

TDI, TMS

BST input; may float or be tied to HIGH

User I/O

TDO

BST output; may float or be connected to TDI of another device

User I/O

A40MX02 bảng dữ liệu(PDF) 19 Page - Microsemi Corporation