PIC18F2525IPQTP datasheet(168/412 Pages) MICROCHIP

168 / 412 page

PIC18F2525/2620/4525/4620

DS39626E-page 166

17.3.5

MASTER MODE

The master can initiate the data transfer at any time

because it controls the SCK. The master determines

when the slave (Processor 2, Figure 17-2) is to

broadcast data by the software protocol.

In Master mode, the data is transmitted/received as

soon as the SSPBUF register is written to. If the SPI

operation is only going to receive, the SDO output

could be disabled (programmed as an input). The

SSPSR register will continue to shift in the signal

present on the SDI pin at the programmed clock rate.

As each byte is received, it will be loaded into the

SSPBUF register as if a normal received byte (inter-

rupts and status bits appropriately set). This could be

useful in receiver applications as a “Line Activity

Monitor” mode.

The clock polarity

is selected by appropriately

programming the CKP bit (SSPCON1<4>). This then,

would give waveforms for SPI communication, as

shown in Figure 17-3, Figure 17-5 and Figure 17-6,

where the MSB is transmitted first. In Master mode, the

SPI clock rate (bit rate) is user programmable to be one

of the following:

•FOSC/4 (or TCY)

•FOSC/16 (or 4 • TCY)

•FOSC/64 (or 16 • TCY)

• Timer2 output/2

This allows a maximum data rate (at 40 MHz) of

10.00 Mbps.

Figure 17-3 shows the waveforms for Master mode.

When the CKE bit is set, the SDO data is valid before

there is a clock edge on SCK. The change of the input

sample is shown based on the state of the SMP bit. The

time when the SSPBUF is loaded with the received

data is shown.

FIGURE 17-3:

SPI MODE WAVEFORM (MASTER MODE)

SCK

(CKP = 0

SCK

(CKP = 1

SCK

(CKP = 0

SCK

(CKP = 1

4 Clock

Modes

Input

Sample

Input

Sample

SDI

bit 7

bit 0

SDO

bit 7

bit 6

bit 5

bit 4

bit 3

bit 2

bit 1

bit 0

bit 7

SDI

SSPIF

(SMP = 1)

(SMP = 0)

(SMP = 1)

CKE = 1)

CKE = 0)

CKE = 1)

CKE = 0)

(SMP = 0)

Write to

SSPBUF

SSPSR to

SSPBUF

SDO

bit 7

bit 6

bit 5

bit 4

bit 3

bit 2

bit 1

bit 0

(CKE = 0)

(CKE = 1)

Next Q4 Cycle

after Q2

↓

bit 0

PIC18F2525IPQTP bảng dữ liệu(PDF) 168 Page - Microchip Technology

PIC18F2525IPQTP bảng dữ liệu(HTML) 168 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL