M95160-R datasheet(28/47 Pages) STMICROELECTRONICS

tên linh kiện	M95160-R

Giải thích chi tiết về linh kiện	16-Kbit serial SPI bus EEPROM with high-speed clock

PDF	47 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

28 / 47 page

Instructions

M95160 M95160-W M95160-R M95160-DF

28/47

DocID022580 Rev 4

6.9

Read Lock Status (available only in M95160-D devices)

The Read Lock Status (RDLS) instruction is used to read the lock status.

To send this instruction to the device, Chip Select (S) first has to be driven low. The bits of

the instruction byte and address bytes are then shifted in (MSB first) on Serial Data input

(D). Address bit A10 must be 1; all other address bits are Don't Care (it might be easier to

define these bits as 0, as shown in Table 4). The Lock bit is the LSB (Least Significant Bit) of

the byte read on Serial Data output (Q). It is at ‘1’ when the lock is active and at ‘0’ when the

lock is not active. If Chip Select (S) continues to be driven low, the same data byte is shifted

out.

The read cycle is terminated by driving Chip Select (S) high. The instruction sequence is

shown in Figure 17.

The Read Lock Status instruction is not accepted and not executed if a Write cycle is

currently in progress.

Figure 17. Read Lock Status sequence

Ai15966

9 10

20 21 22 23 24 25 26 27

14 13

28 29 30

76543

High impedance

Data Out 1

Instruction

16-bit address

MSB

Data Out 2

M95160-R bảng dữ liệu(PDF) 28 Page - STMicroelectronics