STLUX385A datasheet(58/99 Pages) STMICROELECTRONICS

tên linh kiện	STLUX385A

Giải thích chi tiết về linh kiện	Digital controller for lighting and power conversion applications

PDF	99 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

58 / 99 page

Option bytes

STLUX385A

58/98

DocID024387 Rev 2

Bit 7:2:

Rst_PWM[5:0] configures the PWM[n] reset value after the NRST signal

0: PWM[n] output low level (native default value)

1: PWM[n] output high level

Note:

The PWM signal programmed reset value is configured during the option byte loader phase,

then before the NRST is released it assumes its proper initial values.

nGENCFG (general configuration reg. protect.)

nGENCFG: not(GENCFG) EMC byte protection

MISCUOPT (miscellaneous config. reg.)

Bit 0:

WWdg_HALT window watchdog reset on Halt:

0: No reset generated on Halt if WWDG is active

1: Reset generated on Halt if WWDG is active

Bit 1:

WWdg_hw window watchdog hardware enable:

0: Window watchdog activation by SW

1: Window watchdog activation by HW

Bit 2:

IWdg_hw independent watchdog hardware enable:

0: Independent watchdog activation by SW

1: Independent watchdog activation by HW

Offset: 0x004804

Default value: 0xFF

65432

Rst_PWM [5:0]

nCOMP1_2

nEN_COLD_C

r/w

Offset: 0x004805

Default value: 0x28 (factory configuration)

654

RFU

LSI_EN

lWdg_hw

WWdg_hw

WWdg_HAL

r/w

STLUX385A bảng dữ liệu(PDF) 58 Page - STMicroelectronics

STLUX385A bảng dữ liệu(HTML) 58 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99

bảng dữ liệu tải về

Link URL