JS28F128P30TF75A datasheet(18/90 Pages) MICRON

18 / 90 page

P30-65nm SBC

Datasheet

Apr 2010

Order Number: 208033-02

5.6

Reset

As with any automated device, it is important to assert RST# when the system is reset.

When the system comes out of reset, the system processor attempts to read from the

flash memory if it is the system boot device. If a CPU reset occurs with no flash

memory reset, improper CPU initialization may occur because the flash memory may

be providing status information rather than array data. Flash memory devices from

NumonyxTM allow proper CPU initialization following a system reset through the use of

the RST# input.

After initial power-up or reset, the device defaults to asynchronous Read Array mode,

and the Status Register is set to 0x80.

When RST# is driven low (RST# asserted), the flash device enters reset mode. Then all

internal circuits are de-energized, and the output drivers are placed in High-Z. If RST#

is asserted during a program or erase operation, the operation is terminated and the

memory contents at the aborted location (for a program) or block (for an erase) are no

longer valid. A device reset also clears the Status Register. See Table 18, “Power and

Reset” on page 43 for RST# timing detail.

When RST# is driven high (RST# deasserted), a minimum wait is required before the

flash device is able to perform normal operations. Please consider TPHQV (R5) and

TPHWL (W1) during system design. see Table 25, “AC Read Specifications” on page 50.

and Section 26, “AC Write Specifications” on page 54. After this wake-up interval

passes, normal operation is ready for execution.

JS28F128P30TF75A bảng dữ liệu(PDF) 18 Page - Micron Technology