OR3C80 datasheet(73/210 Pages) AGERE

73 / 210 page

Lucent Technologies Inc.

Data Sheet

June 1999

ORCA Series 3C and 3T FPGAs

Programmable Clock Manager (PCM) (continued)

PCM Registers

The PCM contains eight user-programmable registers used for configuring the PCM’s functionality. Table 26 shows

the mapping of the registers and their functions. See Figure 46 for more information on the location of PCM ele-

ments that are discussed in the table. The PCM registers are referenced in the discussions that follow. Detailed

explanations of all register bits are supplied following the functional description of the PCM.

Table 26. PCM Registers

Address

Function

Divider 0 Programming. Programmable divider, DIV0, value and DIV0 reset bit. DIV0 can

divide the input clock to the PCM or can be bypassed.

Divider 1 Programming. Programmable divider, DIV1, value and DIV1 reset bit. DIV1 can

divide the feedback clock input to the PCM or can be bypassed. Valid only in PLL mode.

Divider 2 Programming. Programmable divider, DIV2, value and DIV2 reset bit. DIV2 can

divide the output of the tapped delay line or can be bypassed and is only valid for the

ExpressCLK

output.

DLL 2x Duty-Cycle Programming. DLL mode clock doubler (2x) duty-cycle selection.

DLL 1x Duty-Cycle Programming. Depending on the settings in other registers, this regis-

ter is for:

a. PLL mode phase/delay selection;

b. DLL mode 1x duty cycle selection; and

c. DLL mode programmable delay.

Mode Programming. DLL/PLL mode selection, DLL 1x/2x clock selection, phase detector

feedback selection.

Clock Source Status/Output Clock Selection Programming. Input clock selection, feed-

back clock selection, ExpressCLK output source selection, system clock output source selec-

tion.

PCM Control Programming. PCM power, reset, and configuration control.

OR3C80 bảng dữ liệu(PDF) 73 Page - Agere Systems