| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
MCP19111 bảng dữ liệu(PDF) 49 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP19111 bảng dữ liệu(HTML) 49 Page - Microchip Technology |
|
49 / 222 page ![]() 2013 Microchip Technology Inc. DS22331A-page 49 MCP19111 6.14 Analog Blocks Enable Control Various analog circuit blocks can be enabled or disabled, as shown in Register 6-15. Addition enable bits are located in the ATSTCON register. 6.14.1 OUTPUT OVERVOLTAGE ENABLE The output overvoltage is enabled by setting the ABECON<OVDCEN> bit. Clearing this bit will disable the output overvoltage circuitry and cause the setting in the OOVCON register to be ignored. 6.14.2 OUTPUT UNDER VOLTAGE ENABLE The output under voltage is enabled by setting the ABECON<UVDCEN> bit. Clearing this bit will disable the output under voltage circuitry and cause the setting in the OUVCON register to be ignored. 6.14.3 RELATIVE EFFICIENCY MEASUREMENT CONTROL Section 10.0 “Relative Efficiency Measurement” describes the procedure used to measure the relative efficiency of the system. Setting the ABECON<MEASEN> bit initiates the relative measurement. 6.14.4 SLOPE COMPENSATION CONTROL The slope compensation described in Register 6-7 can be bypassed by setting the ABECON<SLCPBY> bit. Under normal operation, this bit will always be set. 6.14.5 CURRENT MEASUREMENT CONTROL The peak current measurement circuitry is controlled by the ABECON<CRTMEN> bit. Setting this bit enables the current measurement circuitry. Under normal operation, this bit will be set. 6.14.6 INTERNAL TEMPERATURE MEASUREMENT CONTROL The internal temperature of the silicon can be measured with the ADC. To enable the internal temperature measurement circuitry, the ABECON<TMPSEN> bit must be set. 6.14.7 RELATIVE EFFICIENCY CIRCUITY CONTROL Section 10.0 “Relative Efficiency Measurement” describes the procedure used to measure the relative efficiency of the system. Setting the ABECON<RECIREN> bit enables the relative efficiency measurement circuitry. 6.14.8 SIGNAL CHAIN CONTROL Setting the ABECON<PATHEN> bit enables the voltage control path. Under normal operation, this bit is set. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |