WM8352 datasheet(152/336 Pages) WOLFSON

152 / 336 page

WM8352

Production Data

PD, February 2011, Rev 4.4

152

17 POWER SUPPLY CONTROL

17.1 GENERAL DESCRIPTION

The WM8352 can take its power supply from a Wall adaptor, a USB interface or from a single-cell

lithium battery. The WM8352 autonomously chooses the most appropriate power source available,

and supports hot-swapping between sources (ie. the system can remain in operation while different

sources are connected and disconnected).

Comparators within the WM8352 identify which power supplies are available and select the power

source in the following order of preference:



Wall adaptor (LINE pins)



USB power rail (USB pins)



Battery (BATT pins)

Note that the Wall supply is always the first choice of supply, (providing that it is within required

limits), even if the Wall supply voltage is lower than the USB voltage.

When Wall or USB is selected as the power source, this may be used to charge the Battery, using

the integrated battery charger circuit. For battery charging to occur, the USB or LINE supply voltage

must be no less than 4.0V.

Figure 74 illustrates the WM8352 connections associated with the WALL, USB and Battery supplies.

Figure 74 WM8352 Power Supply Connections

The Wall Adaptor supply connects to LINE via a FET switch as illustrated in Figure 74. The FET

switch is necessary in order to provide isolation between the Wall supply and the Battery/USB

supplies; this is vital in the event of the USB voltage being greater than the Wall supply voltage.

The Wall Adapter voltage is sensed directly on the WALL_FB pin; this allows the WM8352 to

determine the preferred supply, including when the FET is switched off.

The gate connection to the external FET is controlled by LINE_SW, which is an alternate function

that can be enabled on GPIO12 (see Section 20). Note that, if the USB connection is not used, then

the FET may not be required and the Wall supply may be connected directly to LINE.

LINE is primarily an output from the WM8352; this output is the preferred supply, where the WM8352

has arbitrated between the Wall, Battery and USB connections. This output is suitable for supplying

power to the other blocks of the WM8352, including the DC-DC Converters and LDO Regulators.

LINE is also an input under some conditions, such as battery charging from Wall or providing power

at the USB connection.

WM8352 bảng dữ liệu(PDF) 152 Page - Wolfson Microelectronics plc