73S8024RN-ILSLASHF datasheet(12/27 Pages) MAXIM

tên linh kiện	73S8024RN-IL/F

Giải thích chi tiết về linh kiện	Low-Cost Smart Card Interface

PDF	27 Pages

Scroll/Zoom	100%

nhà sản xuất	MAXIM [Maxim Integrated Products]

Trang chủ	https://www.maximintegrated.com/en.html

Logo

12 / 27 page

73S8024RN Data Sheet

DS_8024RN_020

Rev. 2

8 Deactivation Sequence

Deactivation is initiated either by the system controller by setting the CMDVCC high, or automatically in

the event of hardware faults. Hardware faults are over-current, overheating, VDD fault, VPC fault, VCC fault,

and card extraction during the session. To be noted that VPC and VCC faults are linked together so that a

fault is generated when VPC goes lower than VCC.

The following steps show the deactivation sequence and the timing of the card control signals when the

system controller sets the CMDVCC high or OFF goes low due to a fault or card removal:

•

RST goes low at the end of t1.

•

CLK is set low at the end of t2.

•

I/O goes low at the end of t3. Out of reception mode.

•

VCC is shut down at the end of time t4. After a delay t5 (discharge of the VCC capacitor), VCC is low.

RST

CLK

I/O

VCC

CMDVCC

-- OR --

OFF

t1 = > 0.5µs, timing by 1.5MHz internal Oscillator

t2 = > 7.5µs

t3 = > 0.5µs

t4 = > 0.5µs

t5 = depends on VCC filter capacitor.

For NDS application, CF=1µF makes t1 + t2 + t3 + t4 + t5 < 100µs

Figure 4: Deactivation Sequence

73S8024RN-IL/F bảng dữ liệu(PDF) 12 Page - Maxim Integrated Products