Data Sheet

ADIS16136

Rev. A | Page 19 of 20

INSTALLATION TIPS

Figure 24 and Figure 25 provide the mechanical design infor-

mation used for the ADIS16136/PCBZ. Use these figures when

implementing a connector-down approach, where the mating

connector and the ADIS16136AMLZ are on the same surface.

When designing a connector-up system, use the mounting holes

shown in Figure 24 as a guide in designing the bulkhead mounting

system, and use Figure 25 as a guide in developing the mating

connector interface on a flexible circuit or other connector system.

The mating connector pattern in Figure 25 assumes the use of

the Samtec CLM-112-02 series of connectors.

Figure 24. Suggested Mounting Hole Locations, Connector Down

Figure 25. Suggested Layout and Mechanical Design for the Mating Connector

2x

0.560 BSC

ALIGNMENT HOLES

FOR MATING SOCKET

5.00 BSC

39.60 BSC

19.800 BSC

31.200 BSC

15.600 BSC

5.00 BSC

4x

2.500 BSC

2.280

17.520

0.4334 [11.0]

0.0240 [0.610]

0.019685

[0.5000]

(TYP)

0.054 [1.37]

0.0394 [1.00]

0.0394 [1.00]

0.1800

[4.57]

NONPLATED

THRU HOLE 2×

0.022±

DIA (TYP)

0.022 DIA THRU HOLE (TYP)

NONPLATED THRU HOLE