3.45 (87.6) Reference

(lead center to lead center)

0.000

0.120 (3.05)

0.250 (6.35)

0.450 (11.43)

0.650 (16.51)

0.850 (21.59)

1.050 (26.67)

1.250 (31.75)

1.380 (35.05)

0.128 dia

(3.25)

0.040 dia

(1.02)

TOP VIEW CASE V*

Flanged case, down leaded

*Designator "V" required in Case Option position of model number.

1

2

3

4

5

6

12

11

10

9

8

7

Maximum dimensions: 3.005 x 1.505 (76.33 x 38.23 mm)

Angled corner

indicates pin one.

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device. Solder pins

individually with heat application not exceeding 300°C for 10 seconds per pin.

Materials

Header

Cold Rolled Steel/Nickel/Gold

Cover

Kovar/Nickel

Pins

#52 alloy/Gold, compresssion glas seal

Seal Hole: 0.120 ±0.002 (3.05 ±0.05)

Case V, Rev E, 20100106

Please refer to the numerical dimensions for accuracy. All information is believed to

be accurate, but no responsibility is assumed for errors or omissions. Interpoint

reserves the right to make changes in products or specifications without notice.

Copyright © 1999-2009 Interpoint Corp. All rights reserved.

Seam Seal

Crane Aerospace & Electronics Power Solutions

Mor single and dual dc/dc converter cases

28 Volt input – 120 Watt

www.interpoint.com

Page 19 of 24

MOR Rev K - 20100422