352 datasheet(91/95 Pages) INTEL

91 / 95 page

Datasheet

Boxed Processor Specifications

7.1.2

Boxed Processor Fan Heatsink Weight

The boxed processor fan heatsink will not weigh more than 550 grams. See Chapter 5

and the appropriate processor Thermal and Mechanical Design Guidelines (see

Section 1.2) for details on the processor weight and heatsink requirements.

7.1.3

Boxed Processor Retention Mechanism and Heatsink

Attach Clip Assembly

The boxed processor thermal solution requires a heatsink attach clip assembly, to

secure the processor and fan heatsink in the baseboard socket. The boxed processor

will ship with the heatsink attach clip assembly.

7.2

Electrical Requirements

7.2.1

Fan Heatsink Power Supply

The boxed processor's fan heatsink requires a +12 V power supply. A fan power cable

will be shipped with the boxed processor to draw power from a power header on the

baseboard. The power cable connector and pinout are shown in Figure 20. Baseboards

must provide a matched power header to support the boxed processor. Table 35

contains specifications for the input and output signals at the fan heatsink connector.

The fan heatsink outputs a SENSE signal that is an open-collector output that pulses at

a rate of two pulses per fan revolution. A baseboard pull-up resistor provides VOH to

match the system board-mounted fan speed monitor requirements, if applicable. Use of

the SENSE signal is optional. If the SENSE signal is not used, pin 3 of the connector

should be tied to GND.

The fan heatsink receives a PWM signal from the motherboard from the fourth pin of

the connector labeled as CONTROL.

Figure 19.

Space Requirements for the Boxed Processor (Overall View)

352 bảng dữ liệu(PDF) 91 Page - Intel Corporation