SS22SDP2 datasheet(24/48 Pages) TI1

24 / 48 page

Evaluating Performance with the ADCPro Software

www.ti.com

Figure 24. Install New Driver Wizard Screen 5

Step 5.

Once Windows finishes installing the software driver, the plug-in downloads the firmware to

the MMB0. The status area will display Connected to EVM when the device is connected and

ready to use. If the firmware does not load properly, you can try resetting the MMB0 by

pressing reset and then reloading the plug-in.

Step 6.

You can verify the proper installation of the USBStyx driver using the Device Manager. Note

that the first driver item, NI-VISA USB Devices, will disappear and a new item, LibUSB-Win32

Devices will appear, as Figure 25 shows.

Figure 25. USBSytx Driver Verification Using Device Manager

The driver installation wizard sequence should not appear again, unless you connect the board to a

different USB port.

The evaluation software is based on ADCPro, a program that operates using a variety of plug-ins. (The

ADS1274EVM plug-in is installed as described in the installation section, .)

To use ADCPro, load an EVM plug-in and a test plug-in. To load an EVM plug-in, select it from the EVM

menu. To load a test plug-in, select it from the Test menu. To unload a plug-in, select the Unload option

from the corresponding menu.

ADS1174EVM, ADS1274EVM, ADS1174EVM-PDK, and ADS1274EVM-PDK

SBAU134A – August 2008 – Revised May 2009

Submit Documentation Feedback

SS22SDP2 bảng dữ liệu(PDF) 24 Page - Texas Instruments