VSC060 datasheet(27/166 Pages) MAXIM

27 / 166 page

27 of 166

VSC060

Data Sheet

Revision 4.1

January 2008

3.2.6

05h: General-Purpose I/O Port 5 Data (GPD5)

The following table shows the bit assignments for the General-Purpose I/O Port 5 Data register. Control of

the individual I/O pins in this register can be overridden by the PBC8, PBC9, PBC10, and PBC11 registers

when port bypass control is required.

3.2.7

06h: General-Purpose I/O Port 6 Data (GPD6)

The following table shows the bit assignments for the General-Purpose I/O Port 6 Data register. Control of

the individual I/O pins in this register can be overridden by the PBC12, PBC13, PBC14, and PBC15

registers when port bypass control is required.

GPD5

Address:

05h

Reset Value:

XXXX_XXXXb

Bit

Bit Label

Access

Description

7:0

GPD5.7-0

R/W

General-Purpose Data

When the I/O pin is enabled as an output, writing these bits determines the data

value that will be present on the corresponding I/O pin.

If the I/O pin is enabled as an input, reading these register bits represents the

current voltage applied to the pin. At no time do the bits directly represent the

value latched into the data register.

If a pin is enabled as an input and there is no signal applied, weak internal pull-

up resistors hold the pin at a binary 1.

After a reset or power on, the register bits are set to a binary 1, but the value

returned from a register read is the level applied to the pin since each pin is an

input by default.

GPD6

Address:

06h

Reset Value:

XXXX_XXXXb

Bit

Bit Label

Access

Description

7:0

GPD6.7-0

R/W

General-Purpose Data

When the I/O pin has been enabled as an output, writing these bits determines

the data value that will be present on the corresponding I/O pin.

If the I/O pin has been enabled as an input, reading these register bits represents

the current voltage applied to the pin. At no time do the bits directly represent the

value latched into the data register.

If a pin is enabled as an input and there is no signal applied, weak internal pull-up

resistors hold the pin at a binary 1.

After a reset or power on, the register bits are set to a binary 1, however, the

value returned from a register read is the level applied to the pin since each pin is

an input by default.

VSC060 bảng dữ liệu(PDF) 27 Page - Maxim Integrated Products

VSC060 bảng dữ liệu(HTML) 27 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL