SPMCK16Z4MPV16 datasheet(453/500 Pages) FREESCALE

453 / 500 page

M68HC16 Z SERIES

INITIALIZATION AND PROGRAMMING EXAMPLES

USER’S MANUAL

E-1

APPENDIX E

INITIALIZATION AND PROGRAMMING EXAMPLES

This section contains basic initialization programs and several programming exercises

using different M68HC16 Z-series modules. The purpose of these exercises is to pro-

vide the designer and programmer with a means to shorten design time. All of the pro-

grams were written to run on the M68HC16Z1EVB evaluation board. Refer to the

M68HC16Z1EVB Evaluation Board User’s Manual (M68HC16Z1EVB/D) for further in-

formation.

NOTE

These programs will also work on the Modular Evaluation Board

(MEVB) using a microcontroller personality board for the appropriate

Z-series derivative. See APPENDIX C DEVELOPMENT SUPPORT

for more information on the MEVB.

E.1 Initialization Programs

The following initialization routines accompany the programming examples used in

this manual. For information on assembler commands and directives, refer to the

M68HC16Z1EVB Evaluation Board User’s Manual (M68HC16Z1EVB/D).

•

EQUATES.ASM — This program lists of all the MC68HC16 registers equated to

their memory address. This allows programmers to use the register name in their

programs, and then the assembler selects the correct memory address for that

•

ORG00000.ASM — This program consists of five lines of code that set the reset

vector information into the proper locations.

•

ORG00008.ASM — This program initializes the interrupt/exception vectors

($0008 – $01FE). If an interrupt occurs requiring the use of any of these vectors,

program flow continues at the label “BDM”. The programmer must add code at

the label location to put the program running on the EVB16 into background de-

bug mode or some other appropriate routine.

•

INITSYS.ASM — This program consists of ten to twelve lines of code that initial-

ize the system clock, set the extension registers, and chip-selects. It also turns off

the COP (software watchdog) that is set to “on” after reset.

•

INITRAM.ASM — This program initializes the 1-Kbyte internal SRAM at $10000,

and sets the stack inside it.

•

INITSCI.ASM — This program initializes the SCI to transmit and receive at 9600

baud.

NOTE

These programs and others can be obtained from the Freescale web

site at http://www.freescale.com

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

SPMCK16Z4MPV16 bảng dữ liệu(PDF) 453 Page - Freescale Semiconductor, Inc

SPMCK16Z4MPV16 bảng dữ liệu(HTML) 453 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL