TL16CP754C datasheet(16/49 Pages) TI

16 / 49 page

Divisor = (XTAL crystal input frequency / prescaler) / (desired baud rate

16)

1 when CLKSEL = high during reset, or MCR[7] is set to 0 after reset

4 when CLKSEL = low during reset, or MCR[7] is set to 1 after reset

prescaler =

Prescaler Logic

(Divide By 1)

Prescaler Logic

(Divide By 4)

Internal

Oscillator

Logic

Bandrate

Generator

Logic

XTAL1

XTAL2

Internal

Bandrate Clock

For Transmitter

and Receiver

MCR[7] = 0

MCR[7] = 1

Input Clock

Reference

Clock

TL16CP754C, TL16CM754C, TL16C754C

SLLS644E – DECEMBER 2007 – REVISED MAY 2010

www.ti.com

Programmable Baud Rate Generator

The '754C UART contains a programmable baud generator that divides reference clock by a divisor in the range

between 1 and (216

−1). The output frequency of the baud rate generator is 16× the baud rate. An additional

divide-by-4 prescaler is also available and can be selected by the CLKSEL pin or MCR[7], as shown in the

following. The formula for the divisor is:

Where

Figure 9 shows the internal prescaler and baud rate generator circuitry.

Figure 9. Prescaler and Baud Rate Generator Block Diagram

DLL and DLH must be written to in order to program the baud rate. DLL and DLH are the least significant and

most significant byte of the baud rate divisor. If DLL and DLH are both zero, the UART is effectively disabled, as

no baud clock is generated. The programmable baud rate generator is provided to select both the transmit and

receive clock rates. Table 5 and Table 6 show the baud rate and divisor correlation for the crystal with frequency

1.8432 MHz and 3.072 MHz, respectively.

Submit Documentation Feedback

Product Folder Link(s): TL16CP754C TL16CM754C TL16C754C

TL16CP754C bảng dữ liệu(PDF) 16 Page - Texas Instruments

TL16CP754C bảng dữ liệu(HTML) 16 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

bảng dữ liệu tải về

Link URL