PIC12F1822-ISLASHMF datasheet(232/398 Pages) MICROCHIP

232 / 398 page

PIC12F/LF1822/16F/LF1823

DS41413A-page 232

Preliminary

 2010 Microchip Technology Inc.

24.2.3

SPI MASTER MODE

The master can initiate the data transfer at any time

because it controls the SCK line. The master

determines when the slave (Processor 2, Figure 24-5)

is to broadcast data by the software protocol.

In Master mode, the data is transmitted/received as

soon as the SSP1BUF register is written to. If the SPI

is only going to receive, the SDO output could be dis-

abled (programmed as an input). The SSP1SR register

will continue to shift in the signal present on the SDI pin

at the programmed clock rate. As each byte is

received, it will be loaded into the SSP1BUF register as

if a normal received byte (interrupts and Status bits

appropriately set).

The clock polarity is selected by appropriately

programming the CKP bit of the SSP1CON1 register

and the CKE bit of the SSP1STAT register. This then,

would give waveforms for SPI communication as

shown in Figure 24-6, Figure 24-8 and Figure 24-9,

where the MSB is transmitted first. In Master mode, the

SPI clock rate (bit rate) is user programmable to be one

of the following:

•FOSC/4 (or TCY)

•FOSC/16 (or 4 * TCY)

•FOSC/64 (or 16 * TCY)

• Timer2 output/2

• Fosc/(4 * (SSP1ADD + 1))

Figure 24-6 shows the waveforms for Master mode.

When the CKE bit is set, the SDO data is valid before

there is a clock edge on SCK. The change of the input

sample is shown based on the state of the SMP bit. The

time when the SSP1BUF is loaded with the received

data is shown.

FIGURE 24-6:

SPI MODE WAVEFORM (MASTER MODE)

SCK

(CKP = 0

SCK

(CKP = 1

SCK

(CKP = 0

SCK

(CKP = 1

4 Clock

Modes

Input

Sample

Input

Sample

SDI

bit 7

bit 0

SDO

bit 7

bit 6

bit 5

bit 4

bit 3

bit 2

bit 1

bit 0

bit 7

SDI

SSP1IF

(SMP = 1)

(SMP = 0)

(SMP = 1)

CKE = 1)

CKE = 0)

CKE = 1)

CKE = 0)

(SMP = 0)

Write to

SSP1BUF

SSP1SR to

SSP1BUF

SDO

bit 7

bit 6

bit 5

bit 4

bit 3

bit 2

bit 1

bit 0

(CKE = 0)

(CKE = 1)

bit 0

PIC12F1822-I/MF bảng dữ liệu(PDF) 232 Page - Microchip Technology

PIC12F1822-I/MF bảng dữ liệu(HTML) 232 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL