ATmega64A datasheet(324/392 Pages) ATMEL

324 / 392 page

324

8160C–AVR–07/09

ATmega64A

27.9.14

Entering Programming Mode

Enter JTAG instruction AVR_RESET and shift 1 in the Reset Register.

Enter instruction PROG_ENABLE and shift 1010_0011_0111_0000 in the Programming

Enable Register.

27.9.15

Leaving Programming Mode

Enter JTAG instruction PROG_COMMANDS.

Disable all programming instructions by using no operation instruction 11a.

Enter instruction PROG_ENABLE and shift 0000_0000_0000_0000 in the Programming

Enable Register.

Enter JTAG instruction AVR_RESET and shift 0 in the Reset Register.

27.9.16

Performing Chip Erase

Enter JTAG instruction PROG_COMMANDS.

Start chip erase using programming instruction 1a.

Poll for chip erase complete using programming instruction 1b, or wait for t

WLRH_CE (refer

to Table 1 on page 308).

27.9.17

Programming the Flash

Before programming the Flash, a Chip Erase must be performed. See “Performing Chip Erase”

on page 324.

Enter JTAG instruction PROG_COMMANDS.

Enable Flash write using programming instruction 2a.

Load address high byte using programming instruction 2b.

Load address low byte using programming instruction 2c.

Load data using programming instructions 2d, 2e and 2f.

Repeat steps 4 and 5 for all instruction words in the page.

Write the page using programming instruction 2g.

Poll for Flash write complete using programming instruction 2h, or wait for t

WLRH_FLASH

(refer to Table 1 on page 308).

Repeat steps 3 to 7 until all data have been programmed.

A more efficient data transfer can be achieved using the PROG_PAGELOAD instruction:

Enter JTAG instruction PROG_COMMANDS.

Enable Flash write using programming instruction 2a.

Load the page address using programming instructions 2b and 2c. PCWORD (refer to

Table 27-9 on page 300) is used to address within one page and must be written as 0.

Enter JTAG instruction PROG_PAGELOAD.

Load the entire page by shifting in all instruction words in the page, starting with the LSB

of the first instruction in the page and ending with the MSB of the last instruction in the

page.

Enter JTAG instruction PROG_COMMANDS.

Write the page using programming instruction 2g.

Poll for Flash write complete using programming instruction 2h, or wait for t

WLRH_FLASH

(refer to Table 1 on page 308).

Repeat steps 3 to 8 until all data have been programmed.

ATmega64A bảng dữ liệu(PDF) 324 Page - ATMEL Corporation

ATmega64A bảng dữ liệu(HTML) 324 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL