ATXMEGA64A1 datasheet(44/99 Pages) ATMEL

44 / 99 page

8067I–AVR–04/09

XMEGA A1

26. AC - Analog Comparator

26.1

Features

• Four Analog Comparators

• Selectable Power vs. Speed

• Selectable hysteresis

– 0, 20 mV, 50 mV

• Analog Comparator output available on pin

• Flexible Input Selection

– All pins on the port

– Output from the DAC

– Bandgap reference voltage.

– Voltage scaler that can perform a 64-level scaling of the internal VCC voltage.

• Interrupt and event generation on

– Rising edge

– Falling edge

–Toggle

• Window function interrupt and event generation on

– Signal above window

– Signal inside window

– Signal below window

26.2

Overview

XMEGA A1 features four Analog Comparators (AC). An Analog Comparator compares two volt-

ages, and the output indicates which input is largest. The Analog Comparator may be configured

to give interrupt requests and/or events upon several different combinations of input change.

Both hysteresis and propagation delays may be adjusted in order to find the optimal operation

for each application.

A wide range of input selection is available, both external pins and several internal signals can

be used.

The Analog Comparators are always grouped in pairs (AC0 and AC1) on each analog port. They

have identical behavior but separate control registers.

Optionally, the state of the comparator is directly available on a pin.

PORTA and PORTB each has one AC pair. Notations are ACA and ACB, respectively.

ATXMEGA64A1 bảng dữ liệu(PDF) 44 Page - ATMEL Corporation