D2T

D2T

3

s MOUNTING

Use M3 mounting screws to mount the switch. Tighten the

screws to a torque of 4 to 6 kgf • cm.

Mounting Holes

Panel Mounting Dimensions

(Panel thickness: 1.5 to 2 mm)

When mounting the D2T to a panel, be sure to insert an

insulation separator between the D2T and the panel.

The actual OT of the D2T must be at least the specified value

and within the permissible OP of the D2T.

Hinge lever

D2T-LT1, D2T-LT1S

s TERMINALS

Angled terminal

Straight terminal

Note: 1. Unless otherwise specified, a tolerance of

± 0.4 mm applies to all dimensions.

2. The above illustrations and dimensions of the pin plunger and hinge lever are for D2T models with angled terminals. Refer to

the dimensions in “Terminals” for the straight terminals of D2T.

Precautions

s SOLDERING

The following soldering conditions are recommended.

When soldering the D2T to a PCB, make sure that no flux will

be on the surface of the PCB.

Soldering

Temperature

Time

Manual

350

°C

3 s max.

Automatic

260

°C

5 s max.