562 datasheet(2/4 Pages) MALLORY

2 / 4 page

Step 4

Use a 2-arm or 3-arm puller and the thrust button

(provided) to remove the cam from the rotor sleeve

(see Figure 2).

WARNING: Do not try to remove the cam by

prying on it with a screwdriver(s). This will

damage the advance assembly.

Step 5

Install the UNILITE® plate assembly into the housing.

Make sure that the cut-out in the plate is directly

below the hole in the housing where the wires will exit

(see Figure 3).

Step 6

Tighten the two nuts that hold the cap clips/brackets

in place. This also secures the UNILITE® plate.

Step 7

Marine Distributors Only

Replace the cap clips using the new aluminum pins

provided.

Step 8

Install the wire grommet. Lubricate the wires with light

oil. Run the wires through the grommet and out of the

distributor housing (see Figure 3).

Step 9

Install the connector onto the wires. Be sure the wires

are in the correct positions (see Figure 4).

Step 10

Install the rotor/shutter wheel assembly. Make sure

that the rotor is fully seated and that it does not rub

the module wires. Replace the cap.

Step 11

If you removed the distributor to install the UNILITE®

Conversion Kit, reinstall the distributor in the engine.

Step 12

Connect the wire harness to the connector. Connect

the 3 wires to the correct locations, as shown in

Figures 5 and 6.

Step 13

Set the ignition timing. Start the engine and recheck

timing.

MALLORY TECHNICAL SUPPORT

(216)688-8300

www.mrgasket.com

FIGURE 2

FIGURE 3

FIGURE 4

Puller

Thrust Button

Remove button

after cam has

been removed

Cam

Grommet

UNILITE® Plate

Assembly

Connector

Red

Brown

Green

Female Connector

Index Rib

Distributor Wire Harness

Red

Brown

Green

562 bảng dữ liệu(PDF) 2 Page - Mallory performance club

562 bảng dữ liệu(HTML) 2 Page - Mallory performance club

Html Pages

1 2 3 4

bảng dữ liệu tải về

Link URL