M16CSLASH62M datasheet(281/615 Pages) RENESAS

281 / 615 page

Appendix Standard Serial I/O Mode 2 (Flash Memory Version)

Mitsubishi microcomputers

M16C / 62A Group

SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

1-262

Erase All Unlocked Blocks Command

This command erases the content of all blocks. Execute the erase all unlocked blocks command as

explained here following.

(1) Transfer the “A716” command code with the 1st byte.

(2) Transfer the verify command code “D016” with the 2nd byte. With the verify command code, the

erase operation will start and continue for all blocks in the flash memory.

The result of the erase operation can be known by reading the status register. Each block can be erase-

protected with the lock bit. For more information, see the section on the data protection function.

Figure 1.29.28. Timing for erasing all unlocked blocks

Lock Bit Program Command

This command writes “0” (lock) for the lock bit of the specified block. Execute the lock bit program

command as explained here following.

(1) Transfer the “7716” command code with the 1st byte.

(2) Transfer addresses A8 to A15 and A16 to A23 with the 2nd and 3rd bytes respectively.

(3) Transfer the verify command code “D016” with the 4th byte. With the verify command code, “0” is

written for the lock bit of the specified block. Write the highest address of the specified block for

addresses A8 to A23.

Lock bit status can be read with the read lock bit status command. For information on the lock bit

function, reset procedure and so on, see the section on the data protection function.

Figure 1.29.29. Timing for the lock bit program

RxD1

TxD1

A716

D016

(M16C reception data)

(M16C transmit data)

RxD1

TxD1

A8 to

A15

A16 to

A23

7716

D016

(M16C reception data)

(M16C transmit data)

M16C/62M bảng dữ liệu(PDF) 281 Page - Renesas Technology Corp