| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
M16C/62M bảng dữ liệu(PDF) 237 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
M16C/62M bảng dữ liệu(HTML) 237 Page - Renesas Technology Corp |
|
237 / 615 page ![]() Description (Flash Memory Version) Mitsubishi microcomputers M16C / 62A Group SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER 1-218 Flash Memory The M16C/62A (flash memory version) contains the flash memory that can be rewritten with a single volt- age. For this flash memory, three flash memory modes are available in which to read, program, and erase: parallel I/O and standard serial I/O modes in which the flash memory can be manipulated using a program- mer and a CPU rewrite mode in which the flash memory can be manipulated by the Central Processing Unit (CPU). Each mode is detailed in the pages to follow. The flash memory is divided into several blocks as shown in Figure 1.25.1, so that memory can be erased one block at a time. Each block has a lock bit to enable or disable execution of an erase or program operation, allowing for data in each block to be protected. In addition to the ordinary user ROM area to store a microcomputer operation control program, the flash memory has a boot ROM area that is used to store a program to control rewriting in CPU rewrite and standard serial I/O modes. This boot ROM area has had a standard serial I/O mode control program stored in it when shipped from the factory. However, the user can write a rewrite control program in this area that suits the user’s application system. This boot ROM area can be rewritten in only parallel I/O mode. Figure 1.25.1. Block diagram of flash memory version 0C000016 0D000016 Block 6 : 64K byte Block 5 : 64K byte 0E000016 Block 4 : 64K byte 0F000016 Block 3 : 32K byte 0F800016 Block 2 : 8K byte 0FA00016 Block 1 : 8K byte Block 0 : 16K byte 0FC00016 User ROM area 8K byte 0FE00016 0FFFFF16 0FFFFF16 Boot ROM area Flash memory size Flash memory start address 256Kbytes 0C000016 128Kbytes 0E000016 Note 1: The boot ROM area can be rewritten in only parallel input/output mode. (Access to any other areas is inhibited.) Note 2: To specify a block, use the maximum address in the block that is an even address. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |