| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2463 bảng dữ liệu(PDF) 1007 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2463 bảng dữ liệu(HTML) 1007 Page - Renesas Technology Corp |
|
1007 / 1250 page ![]() Section 25 Flash Memory Rev. 2.00 Aug. 20, 2008 Page 959 of 1198 REJ09B0403-0200 7. Initialization When a programming program is downloaded, the initialization program is also downloaded to the on-chip RAM. There is an entry point of the initialization program in the area from the start address specified by FTDAR + 32 bytes of the on-chip RAM. The subroutine is called and initialization is executed by using the following steps. MOV.L #DLTOP+32,ER2 ; Set entry address to ER2 JSR @ER2 ; Call initialization routine NOP The general registers other than R0L are held in the initialization program. R0L is a return value of the FPFR parameter. Since the stack area is used in the initialization program, 128-byte stack area at the maximum must be allocated in RAM. Interrupts can be accepted during the execution of the initialization program. The program storage area and stack area in the on-chip RAM and register values must not be destroyed. 8. The return value in the initialization program, FPFR (general register R0L) is determined. 9. All interrupts and the use of a bus master other than the CPU are prohibited. The specified voltage is applied for the specified time when programming or erasing. If interrupts occur or the bus mastership is moved to other than the CPU during this time, the voltage for more than the specified time will be applied and flash memory may be damaged. Therefore, interrupts and bus mastership to other than the CPU, such as to the DTC, are prohibited. To disable interrupts, bit 7 (I) in the condition code register (CCR) of the CPU should be set to B'1 in interrupt control mode 0 or bits 7 and 6 (I and UI) should be set to B'11 in interrupt control mode 1. Interrupts other than NMI are held and not executed. The NMI interrupts must be masked within the user system. The interrupts that are held must be executed after all program processing. When the bus mastership is moved to other than the CPU, such as to the DTC, the error protection state is entered. Therefore, taking bus mastership by the DTC is prohibited. 10. FKEY must be set to H'5A and the user MAT must be prepared for programming. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |