H838532H datasheet(130/508 Pages) RENESAS

130 / 508 page

Section 5 Power-Down Modes

Rev. 1.00 May 30, 2008 Page 110 of 484

REJ09B0436-0100

5.4

Watch Mode

5.4.1

Transition to Watch Mode

The system goes from active or subactive mode to watch mode when a SLEEP instruction is

executed while the SSBY bit in SYSCR1 is set to 1 and bit TMA3 in TMA is set to 1.

In watch mode, operation of on-chip peripheral modules is halted except for timer A, timer F,

timer G, AEC and the LCD controller/driver (for which operation or halting can be set) is halted.

As long as a minimum required voltage is applied, the contents of CPU registers, the on-chip

RAM and some registers of the on-chip peripheral modules, are retained. I/O ports keep the same

states as before the transition.

5.4.2

Clearing Watch Mode

Watch mode is cleared by an interrupt (timer A, timer F, timer G, IRQ

0, or WKP7 to WKP0) or by

input at the

RES pin.

• Clearing by interrupt

When watch mode is cleared by interrupt, the mode to which a transition is made depends on

the settings of LSON in SYSCR1 and MSON in SYSCR2. If both LSON and MSON are

cleared to 0, transition is to active (high-speed) mode; if LSON = 0 and MSON = 1, transition

is to active (medium-speed) mode; if LSON = 1, transition is to subactive mode. When the

transition is to active mode, after the time set in SYSCR1 bits STS2 to STS0 has elapsed, a

stable clock signal is supplied to the entire chip, watch mode is cleared, and interrupt exception

handling starts. Watch mode is not cleared if the I bit of CCR is set to 1 or the particular

interrupt is disabled in the interrupt enable register.

• Clearing by RES input

Clearing by

RES pin is the same as for standby mode; see Clearing by RES pin in section

5.3.2, Clearing Standby Mode.

5.4.3

Oscillator Settling Time after Watch Mode is Cleared

The waiting time is the same as for standby mode; see section 5.3.3, Oscillator Settling Time after

Standby Mode is Cleared.

H838532H bảng dữ liệu(PDF) 130 Page - Renesas Technology Corp