11/19

TDA7476

SOFTWARE SPECIFICATIONS

The TDA7476 is activated by turning-on the ST-BY pin (CMOS compatible). In this condition it waits for the

I2CBus addressing byte ADD1 (WRITE to TDA7476)

This sequence (where the bit 0 of ADD1 is at 0 level) enables the acquisition routine and starts the single pulse

(containing infrasonic harmonics) for the test. During this period the data regarding all the outputs are memo-

rized.After a period Twait1 that depends on the value of the timing capacitor (see Timing) the

µP redirects the

TDA7476 by the byte ADD2.

The byte ADD2 contains the bit 0 at 1 level. This enables the reading mode, TDA7476's. The 3 bytes with the

diagnostic information BYTE1, BYTE2, BYTE3 (READ FROM TDA7476) are now transmitted to the

µP.

The address of TDA7476 is selected using pin ADD (pin 4) .

If ADD is connected to ground, then A = 0 and the TDA7476 address is 0100010X.

If ADD is connected to 5V, than A = 1 and the TDA7476 address is 0100011X

s

The TDA7476 provides two types of diagnostic information:

of diagnostic information is activated:

- CH1, CH2, CH3, CH4, CH5

Short Circuit to GND

Short Circuit to Vs

Open Load (*)

Short Circuit across the load (*)

(*) Detected if the power amplifiers are in ST-BY condition.

- AUX1, AUX2

Short Circuit to GND (*)

Open Load (*)

(*) Detected if the high side drivers attached to the Aux outputs are ON.

Here following the turn-on diagnostic output bytes

ADD1

S

010001A

0

ACK

STOP

ADD1

S

010001A

0

ACK

BYTE1

ACK

BYTE2

ACK

BYTE3

ACK

STOP

SCL

SDA

START

STOP

D99AU1032

SCL

1

MSB

23789

SDA

START

ACKNOWLEDGMENT

FROM RECEIVER

D99AU1033