TPA2016D2RGPR datasheet(23/35 Pages) TI

23 / 35 page

TPA2016D2

www.ti.com ............................................................................................................................................................. SLOS524B – JUNE 2008 – REVISED JUNE 2008

IC FUNCTION CONTROL (Address: 1)

I2C BIT

LABEL

DEFAULT

DESCRIPTION

ADDRESS

01 (01H) – IC

SPK_EN_R

1 (enabled)

Enables right amplifier

Function Control

SPK_EN_L

1 (enabled)

Enables left amplifier

SWS

0 (enabled)

Shutdown IC when bit = 1

FAULT_R

Changes to a 1 when there is a short on the right channel. Reset by writing

a 0.

FAULT_L

Changes to a 1 when there is a short on the left channel. Reset by writing a

Thermal

Changes to a 1 when die temperature is above 150°C

UNUSED

NG_EN

1 (enabled)

Enables Noise Gate function

SPK_EN_R:

Enable bit for the right-channel amplifier. Amplifier is active when bit is high. This function is

gated by thermal and returns once the IC is below the threshold temperature.

SPK_EN_L:

Enable bit for the left-channel amplifier. Amplifier is active when bit is high. This function is

gated by thermal and returns once the IC is below the threshold temperature

SWS:

Software shutdown control. The device is in software shutdown when the bit is '1' (control, bias

and oscillator are inactive). When the bit is '0' the control, bias and oscillator are enabled.

Fault_L:

This bit indicates that an over-current event has occurred on the left channel with a '1'. This bit

is cleared by writing a '0' to it.

Fault_R:

This bit indicates that an over-current event has occurred on the right channel with a '1'. This

bit is cleared by writing a '0' to it.

Thermal:

This bit indicates a thermal shutdown that was initiated by the hardware with a '1'. This bit is

deglitched and latched, and can be cleared by writing a '0' to it.

NG_EN:

Enable bit for the Noise Gate function. This function is enabled when this bit is high. This

function can only be enabled when the Compression ratio is not 1:1.

AGC ATTACK CONTROL (Address: 2)

LABEL

DEFAULT

DESCRIPTION

I2C BIT

ADDRESS

02 (02H) –

7:6

Unused

AGC Control

5:0

ATK_time

000101

AGC Attack time (gain ramp down)

(6.4 ms/6 dB)

Per Step

Per 6 dB

90% Range

000001

0.1067 ms

1.28 ms

5.76 ms

000010

0.2134 ms

2.56 ms

11.52 ms

000011

0.3201 ms

3.84 ms

17.19 ms

000100

0.4268 ms

5.12 ms

23.04 ms

(time increases by 0.1067 ms with every step)

111111

6.722 ms

80.66 ms

362.99 ms

ATK_time

These bits set the attack time for the AGC function. The attack time is the minimum time

between gain decreases.

Product Folder Link(s): TPA2016D2

TPA2016D2RGPR bảng dữ liệu(PDF) 23 Page - Texas Instruments

TPA2016D2RGPR bảng dữ liệu(HTML) 23 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

bảng dữ liệu tải về

Link URL