ST92163 datasheet(65/224 Pages) STMICROELECTRONICS

65 / 224 page

65/224

ST92163 - INTERRUPTS

WAKE-UP / INTERRUPT LINES MANAGEMENT UNIT (Cont’d)

Case 3: A wake-up event on the external wake-

up lines occurs during the STOP bit setting se-

quence

There are two possible cases:

1. Interrupt requests to the CPU are disabled: in

this case the ST9 will not enter STOP mode, no

interrupt service routine will be executed and

the program execution continues from the

instruction following the STOP bit setting

sequence. The status of STOP and EX_STP

bits will be again:

STOP = 0, EX_STP = 0

The application can determine why the ST9 did

not enter STOP mode by polling the pending

bits of the external lines (at least one must be at

1).

2. Interrupt requests to CPU are enabled: in this

case the ST9 will not enter STOP mode and the

interrupt service routine will be executed. The

status of STOP and EX_STP bits will be again:

STOP = 0, EX_STP = 0

The interrupt service routine can determine why

the ST9 did not enter STOP mode by polling

the pending bits of the external lines (at least

one must be at 1).

If the MCU really exits from STOP Mode, the

RCCU EX_STP bit is still set and must be reset by

software. Otherwise, if an Interrupt/DMA request

was acknowledged during the STOP bit setting se-

quence, the RCCU EX_STP bit is reset. This

means that the MCU has filtered the STOP Mode

entry request.

The WKUP-INT bit can be used by an interrupt

routine to detect and to distinguish events coming

from Interrupt Mode or from Wake-up Mode, allow-

ing the code to execute different procedures.

To exit STOP mode, it is sufficient that one of the

16 wake-up lines (not masked) generates an

event: the clock restarts after the delay needed for

the oscillator to restart.

Note: After exiting from STOP Mode, the software

can successfully reset the pending bits (edge sen-

sitive), even though the corresponding wake-up

line is still active (high or low, depending on the

Trigger Event register programming); the user

must poll the external pin status to detect and dis-

tinguish a short event from a long one (for example

keyboard input with keystrokes of varying length).

ST92163 bảng dữ liệu(PDF) 65 Page - STMicroelectronics

ST92163 bảng dữ liệu(HTML) 65 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL