ST10R272LT1 datasheet(41/77 Pages) STMICROELECTRONICS

41 / 77 page

41/77

ST10R272L - ELECTRICAL CHARACTERISTICS

Remarks on 5 volt tolerant (5T) and 5 volt fail-safe (5S) pins

The 5V tolerant input and output pins can sustain an absolute maximum external voltage of

5.5V.

However, signals on unterminated bus lines might have overshoot above 5.5V, presenting

latchup and hot carrier risks. While these risks are under evaluation, observe the following se-

curity recommendations:

•

Maximum peak voltage on 5V tolerant pin with respect to ground (VSS)= +6 V

•

If the ringing of the external signal exceeds 6V, then clip the signal to the 5V supply.

Power supply failure condition

The power supply failure condition is a state where the chip is NOT supplied but is connected

to active signal lines. There are several cases:

•

3.3V external lines on 3.3V (3T) pin on the non powered chip: ...............NOT Acceptable

•

3.3V external lines on 5V tolerant (5T) pin on the non powered chip: ............. Acceptable

The 5V tolerant buffer do not leak: external signals not altered. No reliability problem.

•

3.3V external lines on 5V fail-safe (5S) pin on the non powered chip: ............ Acceptable

The 5V tolerant buffer do not leak: external signals not altered. No reliability problem.

•

5.5V external lines on 5V tolerant (5T) pin on the non powered chip: ............. Acceptable

For VERY SHORT times only: the buffers do not leak (external signals not altered) but

there is a fast degradation of the gate oxides in the buffers. The total maximum time under

this stress condition is 2 days. This limits this configuration to short power-up/down

sequences. For 10 year life time, the maximum duty factor is 1/1800 allowing e.g. a

maximum stress duration of 48 seconds per day.

•

5.5V external lines on 5V fail-safe (5S) pin on the non powered chip: ............ Acceptable

•

6V transient signals on 5V tolerant (5T) pin on the non powered chip: ...NOT Acceptable

•

6V transient signals on 5V fail-safe (5S) pin on the non powered chip:.......... Acceptable

ST10R272LT1 bảng dữ liệu(PDF) 41 Page - STMicroelectronics