14

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SCREEN SETTINGS

WARNING: DO NOT USE FOR WELDING OUTSIDE THE RANGE OF DIN 9-13.

INJURY TO THE EYES & LOSS OF EYESIGHT MAY BE CAUSED.

On striking an arc, the light created will activate the solar cell and the window will

automatically darken to a pre-set level. The lithium battery will provide the necessary

energy to operate the headshield when there is no arc light. Because the cartridge

assembly is a sealed unit, the battery cannot be replaced. You can adjust this shade

level using the shade adjustment knob on the side of the headshield, corresponding

to the type of welding process.

• There are five levels available; 9, 10, 11, 12 and 13. Check the table on

page 16 to determine which you should select.

SELECT THE GRINDING SETTING

The headshield has a ‘Grinding’ setting on the

selector panel. When set to ‘Grind’ the auto

darkening function is disabled. The headshield

then provides eye and face protection for

sparks and airborne particles created during

grinding activities.

DO NOT WELD WITH “GRIND” SELECTED

SELECT THE SHADE CONTROL

Select the shade DIN 9 to 13 based upon the

welding process you will use by consulting the

"Shade Guide” table. The variable shade

control knob is for internal adjustment. The

welding helmet can also be used to protect the

face when cutting, from shade DIN 5 to 8.

Grind mode DIN 4 prevents filter lens from

auto-darkening for grinding use.