DLS360 datasheet(19/40 Pages) CLARKE

tên linh kiện	DLS360

Giải thích chi tiết về linh kiện	3600PSI DIESEL POWER WASHER

PDF	40 Pages

Scroll/Zoom	100%

nhà sản xuất	CLARKE [Clarke International]

Trang chủ	https://www.clarkeinternational.com/

Logo

19 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

5. Loosen the engine speed control

knob anti-clockwise and slide the

engine speed control knob down to

the ‘START’ position and tighten in

position.

6. Turn the key clockwise to the

‘START’ position. Release the key as

soon as the engine starts. It will

return to the ‘ON’ position.

7. Turn water supply on.

NOTE: If the engine fails to start:

1. Wait until the engine completely stops. Engaging the starter while the engine is

rotating may cause damage to the starter motor and flywheel.

2. Wait at least 30 seconds before you attempt to restart the engine again.

IMPORTANT: Allow the engine to run at no load for five minutes after each

start up so the engine can stabilise.

RECOIL START

1. Make sure the engine has sufficient fuel. See page 17.

2. Check the engine, pump & gearbox oil levels. See page 15-16.

3. Connect the high pressure hose and water inlet hoses. See page 13.

NOTE: The power washer is easier to start if you do not turn the water supply on at

this time, see point 9.

DLS360 bảng dữ liệu(PDF) 19 Page - Clarke International