| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
CSA20FBT bảng dữ liệu(PDF) 10 Page - Clarke International |
|
|
|||||||||||||||||||||||||||||
CSA20FBT bảng dữ liệu(HTML) 10 Page - Clarke International |
|
10 / 20 page ![]() 10 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com constantly monitor the process, ensuring the ram and work remain completely in line and there is no risk of slipping. 6. Observe the reading on the pressure gauge and take care not to exceed the rated working pressure of the press. • The scale from 20 metric tonnes upward is highlighted in red, indicating pressure being applied above the rated maximum working pressure. 7. When the process is complete, turn the release valve control knob anticlockwise in small increments to release ram pressure and allow removal of the workpiece. MAINTENANCE ROUTINELY A visual inspection must be made before each use of the press, checking for leaking hydraulic fluid and damaged, loose, or missing parts. Owners and/or users should be aware that repair of this equipment requires specialised knowledge and facilities. It is recommended that a thorough annual inspection of the press be made and that any defective parts be replaced with genuine Clarke parts. Any press which appears to be damaged in any way, is found to be badly worn, or operates abnormally SHOULD BE REMOVED FROM SERVICE until the necessary repairs are made. If the press is not to be used for any length of time, store it with the ram piston withdrawn to protect the moving parts. PERIODICALLY Check the press frame to make sure all bolts are tight and inspect for cracked welds, bent, loose or missing parts. Owners and/or users should be aware that repair of this equipment requires specialised knowledge and facilities. It is recommended that a thorough annual inspection of the press be made and that any defective parts be replaced with genuine Clarke parts. Check the hydraulic connections for leaks. Replace or properly repair any damaged or leaking hydraulic components before using. In the event of leaking seals, oil can be topped up via the plug on the end of the pump. Oil should be level with the bottom of the hole. If necessary top up with CLARKE hydraulic oil, Part No. 3050830. This task is carried out with the ram fully retracted. If any rust is apparent it must be removed completely and the paint restored. |
|
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |