| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
DIO5081LP10 bảng dữ liệu(PDF) 10 Page - DIOO MICROCIRCUITS CO., LTD |
|
|
|||||||||||||||||||||||||||||
DIO5081LP10 bảng dữ liệu(HTML) 10 Page - DIOO MICROCIRCUITS CO., LTD |
|
10 / 18 page ![]() DIO5081 www.dioo.com © 2023 DIOO MICROCIRCUITS CO., LTD DIO5081• Rev.1.4 Device Functional Modes /CHG and /PG LED Pull-up Source For host monitoring, a pull-up resistor is used between the "STATUS" terminal and the VCC of the host and for a visual indication a resistor in series with an LED is connected between the "STATUS" terminal and a power source. The /CHG or /PG source is capable of exceeding 8 V. If the source is the BAT terminal, note that as the battery changes voltage, and the brightness of the LEDs vary. Charging State /CHG FET/LED Charge after VIN applied ON Refresh Charge OVP OFF SLEEP VIN Power Good State /PG FET/LED UVLO OFF SLEEP Mode OVP Mode TS_disable Normal Input (VBAT + VDT < VIN < VOUP) ON IN-DPM (VIN-DPM or IN-DPM) The IN-DPM feature is used to detect an input source voltage that is folding back, reaching its current limit due to excessive load. When the input voltage drops to the VIN-DPM threshold the internal pass FET starts to reduce the current until there is no further drop in voltage at the input. This would prevent a source with voltage less than VIN-DPM to power the BAT terminal. This works well with current limited adaptors and USB ports as long as the nominal voltage is 4.4V. This is an added safety feature that helps protect the source from excessive loads. BAT The Charger’s BAT terminal provides current to the battery and to the system, if present. This IC can be used to charge the battery plus power the system, charge just the battery or just power the system (TTDM) assuming the loads do not exceed the available current. The BAT terminal is a current limited source and is inherently protected against shorts. If the system load ever exceeds the output programmed current threshold, the output will be discharged unless there is sufficient capacitance or a charged battery present to supplement the excessive load. ISET An external resistor is used to Program the Output Current (50 to 600mA) and can be used as a current monitor. IBAT = (1V / RISET)*450 (1) |
|
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |