12

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

10. After the vehicle is started, remove the black negative battery clamp first, then the

red positive clamp.

11. Recharge the jump starter.

TROUBLESHOOTING

If these remedies are unsuccessful, consult your Clarke dealer.

PROBLEM

CAUSE

SOLUTION

Unit beeps and screen

shows “OUTPUTS

LOCKED”

Battery clamps are

connected backwards

(reverse polarity) or there

is a short circuit.

Disconnect clamps immediately.

Connect them correctly and turn

the unit back on to resume

operation.

Unit fails to jumpstart

vehicle

Broken clamps/cable

Low battery.

Unit damaged internally

Have damaged items replaced.

Recharge the jumpstarter battery.

Take the unit to your Clarke dealer

for repair.

Screen shows

OUTPUTS LOCKED

and keeps flashing

Attempt to jumpstart

more than 3 times in a

short interval.

Jumpstart is in protection mode to

protect its self from overheating.

Wait for 2 minutes while the

battery cools down before

resuming operation.

Screen is blank with

no message shown

USB output or 12V DC

output overload or a short

circuit. Unit protection has

been tripped

Low battery.

Press power button to unlock the

unit and resume operation.

Recharge the jumpstarter.