8

OPERATION

USING YOUR SANDBLASTER

Connect your sandblasting gun to a compressor (minimum 3hp) via the 3/8”

hose adaptor located at the base of the handle.

Set the air pressure on your air compressor to 100 -150 psi.

1. Connect a air hose (sold separately) between your air compressor, and the

hose fitting on the sandblasting gun.

2. Make sure air hole located on the base of the abrasive tank is not covered.

3. Place the mesh filter on top of the drum and pour the blasting medium

through the filter into the drum (max 50 lbs)

4. Start compressor.

5. Check for leaks along all hoses and fittings. if leaks are found, turn off the

air compressor, disconnect the hose and repair immediately.

6. Point the sandblasting gun in a safe direction away from people, pets or

anything around you that may be damaged by direct or indirect abrasive

spray.

7. Press and hold the sandblasting gun trigger until abrasive media is flowing

through the nozzle.

TO STOP BLASTING

1. Release the trigger on the sandblasting gun.