Removal and Replacement
TDS 310, TDS 320 & TDS 350 Instruction Manual
815
1. Have handy a wooden spudger (Item 8).
2. Set the oscilloscope so its rear is down on the work surface and its
bottom is facing you.
DO NOT touch the carbon contact points on the menu elastomer
installedin the trim ring. Also, do not touch the contacts on the menu
button flex circuit exposedwhen you remove the trim ring. You
shouldwear clean cloth gloves that are free of lint when handling the
menu elastomer or when touching the menu button flex circuit
mountedon the front chassis.
3. Grasp the trim ring by its top edge, pry it up, andlift it forwardto snap it
off the top front of the main chassis (see Figure 86).
Trim Ring: Toremove, grasp its back edge
and press up on its two tab locks. Flex the
trim ring upward; then pull it forward.
Repeat for the bottom edge of the trim ring.
Menu Elastomer
Menu Button (17)
Trim Ring
Tab Lock
Figure 86:Trim Ring, Menu Elastomer, and Menu Buttons Removal
4. Repeat the process, prying on the bottom edge of the trim ring to com
plete its removal. Lay the trim ring on its face on the work surface.
5. If you are servicing the front EMI gaskets, discardthe oldones.
6. If you are servicing the menu elastomer, lift it out of the trim ring.
7. If you are servicing the menu buttons, lift them out of the trim ring.
Trim Ring, Menu
Elastomer, Menu
Buttons, and Front
EMI Gaskets
Vietnamese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
