1

OUT

2

GND

3

FLT

4

EN/EN

5

IN

5

TPS2000C, TPS2001C, TPS2041C, TPS2051C, TPS2061C

TPS2065C, TPS2065C-2, TPS2068C, TPS2069C, TPS2069C-2

www.ti.com

SLVSAU6H – JUNE 2011 – REVISED APRIL 2016

Product Folder Links: TPS2000C TPS2001C TPS2041C TPS2051C TPS2061C TPS2065C TPS2065C-2 TPS2068C

TPS2069C TPS2069C-2

Submit Documentation Feedback

Copyright © 2011–2016, Texas Instruments Incorporated

DBV Package

5-Pin SOT-23

Top View

Pin Functions - 5 Pins

PIN

I/O

DESCRIPTION

NAME

NO.

EN/EN

4

I

Enable input, logic high turns on power switch

FLT

3

O

Active-low open-drain output, asserted during overcurrent, or overtemperature conditions

GND

2

—

Ground connection

IN

5

PWR

Input voltage and power-switch drain; connect a 0.1-µF or greater ceramic capacitor from IN to GND

close to the IC

OUT

1

PWR

Power-switch output, connect to load.

(1)

Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings

only, which do not imply functional operation of the device at these or any other conditions beyond those indicated under Recommended

Operating Conditions. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

(2)

Absolute maximum ratings apply over recommended junction temperature range.

(3)

Voltages are with respect to GND unless otherwise noted.

(4)

See Input and Output Capacitance.

7 Specifications

7.1 Absolute Maximum Ratings

over operating free-air temperature range (unless otherwise noted)

(1) (2) (3)

MIN

MAX

UNIT

Voltage on IN, OUT, EN or EN, FLT (4)

–0.3

6

V

Voltage from IN to OUT

–6

6

V

Maximum junction temperature, TJ

Internally Limited

Storage temperature, Tstg

–60

150

°C

(1)

JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.

(2)

JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process.

(3)

VOUT was surged on a PCB with input and output bypassing per the Typical Application Diagram on the first page (except input

capacitor was 22 µF) with no device failures.

7.2 ESD Ratings

VALUE

UNIT

V(ESD)

Electrostatic discharge

Human-body model (HBM), per ANSI/ESDA/JEDEC JS-001(1)

±2000

V

Charged-device model (CDM), per JEDEC specification JESD22-C101(2)

±500

IEC 61000-4-2 contact discharge

±8000

IEC 61000-4-2 air-gap discharge(3)

±15000