ICS3002AI40 datasheet(11/23 Pages) IDT

11 / 23 page

ICS843002I-40

175MHZ, FEMTOCLOCKS™ VCXO BASED SONET/SDH JITTER ATTENUATOR

IDT™ / ICS™ VCXO BASED SONET/SDH JITTER ATTENUATOR

ICS843002AKI-40 REV. A NOVEMBER 7, 2007

Power Supply Filtering Technique

As in any high speed analog circuitry, the power supply pins are

vulnerable to random noise. To achieve optimum jitter

performance, power supply isolation is required. The

ICS843002I-40 provides separate power supplies to isolate any

high switching noise from the outputs to the internal PLL. VCC,

VCCA, VCCO_LVPECL and VCCO_LVCMOS should be individually

connected to the power supply plane through vias, and 0.01µF

bypass capacitors should be used for each pin. Figure 1 illustrates

this for a generic VCC pin and also shows that VCCA requires that

an additional 10

Ω resistor along with a 10µF bypass capacitor be

connected to the VCCA pin.

Figure 1. Power Supply Filtering

Wiring the Differential Input to Accept Single Ended Levels

Figure 2 shows how the differential input can be wired to accept

single ended levels. The reference voltage V_REF = VCC/2 is

generated by the bias resistors R1, R2 and C1. This bias circuit

should be located as close as possible to the input pin. The ratio of

R1 and R2 might need to be adjusted to position the V_REF in the

center of the input voltage swing. For example, if the input clock

swing is only 2.5V and VCC = 3.3V, V_REF should be 1.25V and

R2/R1 = 0.609.

Figure 2. Single-Ended Signal Driving Differential Input

VCC

VCCA

3.3V

Ω

10µF

.01µF

V_REF

Single Ended Clock Input

VCC

CLKx

nCLKx

0.1u

ICS3002AI40 bảng dữ liệu(PDF) 11 Page - Integrated Device Technology