ICS1523MLF datasheet(10/21 Pages) IDT

10 / 21 page

Video Clock Synthesizer with I2C Programmable Delay

MDS ICS1523 Z

Revision 052407

Integrated Device Technology, Inc.

Tech Support: www.idt.com/go/clockhelp

ICS1523

Section 9 Output Termination

9.1 PECL Description

The ICS1523 PECL outputs consist of open-drain,

current-source, pull-down transistors. An external

resistor network permits complete flexibility of logic

levels and source impedance. This section describes

the design procedure to select the resistor values and

the pull-down current for these devices.

9.2 PECL Output Structure

The output stage and external circuitry are shown

below in Figure 9-1. The output devices are open-drain

pull-downs. The two output transistors switch

differentially, steering the current source

(programmable via RSET) from one output to the other.

Figure 9-1 PECL Termination Network

For the high logic level, the output transistor is off, so

the logic level is set by the ratio of R1 and R2 and the

voltage VAA. Generally, VAA will be equal to VDD.

For logic low, the pull-down transistor turns on, pulling

the output voltage down to the low logic level.

Decoupling capacitor C1 should be a 0.01µF

high-frequency ceramic unit, and all power pins on the

ICS1523 should also be decoupled with similar

capacitors.

9.3 PECL Design Assumptions

All referenced voltages in this application note are

positive and referenced to the GND pin of the chip.

However, negative logic levels can be generated by

level shifting, i.e. connecting the VDD pin of the device

to system ground and the GND pin to a negative

voltage.

All logic levels must be between GND and the lesser of

VAA and VDD. Then, nodal equations are written, with

resistances transformed into conductances.

RSET

ICS1523

CLK+ (Pin 21)

Destination

Device

or CLK/2+ (Pin 23)

CLK– (Pin 20)

or CLK/2– (Pin 22)

IREF (Pin 24)

VDD

IPECL

VCC

0.1

µF

0.1

µF

IPECL

* Coaxial cable, microstrip, or stripline, with Z0 = RL. Typically,

coaxial cable, microstrip, or stripline is not required if the distance

from the ICS1523 to the PECL load is short (that is, < 3 cm).

ICS1523MLF bảng dữ liệu(PDF) 10 Page - Integrated Device Technology

ICS1523MLF bảng dữ liệu(HTML) 10 Page - Integrated Device Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

bảng dữ liệu tải về

Link URL