TDA7569BLVPD datasheet(17/41 Pages) STMICROELECTRONICS

tên linh kiện	TDA7569BLVPD

Giải thích chi tiết về linh kiện	4 x 50 W power amplifier with full I2C diagnostics, high efficiency and low voltage operation

PDF	41 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

17 / 41 page

DocID023498 Rev 9

17/41

TDA7569BLV

Diagnostics functional description

4.1

Turn-on diagnostic

It is strongly recommended to activate this function at turn on (standby out) through I2C bus

request. Detectable output faults are:



SHORT TO GND



SHORT TO Vs



SHORT ACROSS THE SPEAKER



OPEN SPEAKER

To verify if any of the above misconnections are in place, a subsonic (inaudible) current

pulse (Figure 23) is internally generated, sent through the speaker(s) and sunk back.The

Turn On diagnostic status is internally stored until a successive diagnostic pulse is

requested (after a I2C reading).

If the "standby out" and "diag. enable" commands are both given through a single

programming step, the pulse takes place first (during the pulse the power stage stays 'off',

showing high impedance at the outputs).

Afterwards, when the Amplifier is biased, the PERMANENT diagnostic takes place. The

previous Turn On state is kept until a short appears at the outputs.

Figure 23. Turn-on diagnostic: working principle

Figure 24 and 25 show SVR and OUTPUT waveforms at the turn-on (stand-by out) with and

without turn-on diagnostic.

Figure 24. SVR and output behavior (Case 1: without turn-on diagnostic)

TDA7569BLVPD bảng dữ liệu(PDF) 17 Page - STMicroelectronics