L5963DN-EHT datasheet(29/49 Pages) STMICROELECTRONICS

tên linh kiện	L5963DN-EHT

Giải thích chi tiết về linh kiện	Automotive dual monolithic switching regulator with LDO and HSD

PDF	49 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

29 / 49 page

DocID028553 Rev 3

29/49

L5963

Application information

7.1

Output inductor (Lo)

The value of the output inductor (Lo) is usually calculated to satisfy the peak-to-peak ripple

current requirement. For the best compromise of cost, size and performance, it is suggested

to keep the inductor current ripple between 20% and 40% of the maximum current.

For example, if

IL = IRipple = 0.3 x IOUT(max).

Where, IOUT(max) is the maximum output current.

Then, the inductor value can be estimated by the following equation:

Equation 2

Where, fSW is the switching frequency, VIN(max) is the maximum input voltage.

If VOUT = 3.3 V, VIN(max) = 26 V, fSW = 250 kHz, IL = 0.3 x 3 A = 0.9 A

Equation 3

The next higher available value should be used, so L = 15 μH.

The peak current flowing in Inductor is IL(peak) = IOUT(max) + IL / 2.

If the Inductor value decreases, the peak current increases. The peak current has to be

lower than the current limit of the device.

An inductor having saturation current higher than the device current limit has to be chosen.

L5963DN-EHT bảng dữ liệu(PDF) 29 Page - STMicroelectronics