301201 datasheet(6/6 Pages) TEC

6 / 6 page

408-1535

6 of 6

Rev S

4. Check the clearance between the bottoming

surfaces of the crimping jaws with the .025 mm

[.001 in.] shim. If the clearance is .025 mm [.001 in.]

or less, the ratchet is considered satisfactory. If the

clearance exceeds .025 mm [.001 in.], the ratchet is

out of adjustment and must be repaired. Refer to

Section 6, REPLACEMENT AND REPAIR.

6. REPLACEMENT AND REPAIR

Replaceable parts are listed in Figure 9. Parts other

than those listed in Figure 9 should be replaced to

ensure quality and reliability of the tool. Order

replacement parts through your TE Connectivity

Representative, or call 1-800-526-5142, or send a

facsimile of your purchase order to 1-717-986-7605, or

write to:

CUSTOMER SERVICE (038-035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105-3608

Tools may also be returned for evaluation and repair.

For tool repair service, please contact a TE

representative at 1-800-526-5136.

7. REVISION SUMMARY

• Updated document to corporate requirements

• Added new information to table in Figure 2

Figure 9

REPLACEMENT PARTS

ITEM

PART NUMBER

DESCRIPTION

QTY PER TOOL

21045-3

RING, Retaining

1-23619-6

PIN, Retaining

39364

SPRING

2-23620-9

PIN, Retaining

21045-6

RING, Retaining

39207

PIN, Insulation Crimping Adjustment

305363

LOCATOR

302994

HOUSING, Locator

9-305927-1

SCREW

301201

SPRING

301201 bảng dữ liệu(PDF) 6 Page - TE Connectivity Ltd

301201 bảng dữ liệu(HTML) 6 Page - TE Connectivity Ltd

Html Pages

1 2 3 4 5 6

bảng dữ liệu tải về

Link URL