TMS28F002AST datasheet(20/79 Pages) TI

20 / 79 page

TMS28F002Axy, TMS28F200Axy

262144 BY 8-BIT/131072 BY 16-BIT

AUTO-SELECT BOOT-BLOCK FLASH MEMORIES

SMJS826D – JANUARY 1996 – REVISED SEPTEMBER 1997

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251–1443

common electrical parameter

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC (see Note 4)

– 0.6 V to 7 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Supply voltage range, VPP (see Note 4)

– 0.6 V to 14 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range: All inputs except A9, RP

– 0.6 V to VCC + 1 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

RP, A9 (see Note 5)

– 0.6 V to 13.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range (see Note 6)

– 0.6 V to VCC + 1 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operating free-air temperature range, TA, during read/erase/program: L suffix

°C to 70°C

. . . . . . . . . . . . . .

E suffix

– 40

°C to 85°C

. . . . . . . . . . . .

Q suffix

– 40

°C to 125°C

. . . . . . . . . .

Storage temperature range, Tstg

– 65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

4. All voltage values are with respect to VSS.

5. The voltage on any input or output can undershoot to – 2 V for periods less than 20 ns. See Figure 8.

6. The voltage on any input or output can overshoot to 7 V for periods less than 20 ns. See Figure 9.

NOTES: A. CL includes probes and fixture capacitance

B. AC test conditions are driven at VIH and VIL. Timing measurements are made at VOH and VOL levels on both inputs and

outputs. See Table 9 for values based on VCC operating range.

C. Each device should have a 0.1-

µF ceramic capacitor connected to VCC and VSS as closely as possible to the device pins.

IOL

IOH

Output

Under

Test

(see Note A)

VIH

VIL

VOLTAGE WAVEFORMS

VOH

VOL

Figure 7. Load Circuit and Voltage Waveforms

–2.0 V

–0.6 V

+0.8 V

20 ns

Figure 8. Maximum Negative Overshoot Waveform

TMS28F002AST bảng dữ liệu(PDF) 20 Page - Texas Instruments

TMS28F002AST bảng dữ liệu(HTML) 20 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

bảng dữ liệu tải về

Link URL