RAMP

(

)

(

)

ON

IN

OUT

RAMP

t

5

V

V

25

C

m ´

-

-

m ´

tON

Sample and Hold DC Level

0.5V/A

13

LM5576, LM5576-Q1

www.ti.com

SNVS447J – JANUARY 2007 – REVISED NOVEMBER 2014

Product Folder Links: LM5576 LM5576-Q1

Submit Documentation Feedback

Copyright © 2007–2014, Texas Instruments Incorporated

Device Functional Modes (continued)

7.4.4 Ramp Generator

The ramp signal used in the pulse width modulator for current mode control is typically derived directly from the

buck switch current. This switch current corresponds to the positive slope portion of the output inductor current.

Using this signal for the PWM ramp simplifies the control loop transfer function to a single pole response and

provides inherent input voltage feed-forward compensation. The disadvantage of using the buck switch current

signal for PWM control is the large leading edge spike due to circuit parasitics that must be filtered or blanked.

Also, the current measurement may introduce significant propagation delays. The filtering, blanking time and

propagation delay limit the minimum achievable pulsewidth. In applications where the input voltage may be

relatively large in comparison to the output voltage, controlling small pulsewidths and duty cycles is necessary for

regulation. The LM5576 utilizes a unique ramp generator, which does not actually measure the buck switch

current but rather reconstructs the signal. Reconstructing or emulating the inductor current provides a ramp

signal to the PWM comparator that is free of leading edge spikes and measurement or filtering delays. The

current reconstruction is comprised of two elements; a sample & hold DC level and an emulated current ramp.

Figure 14. Composition of Current Sense Signal

The sample & hold DC level illustrated in Figure 14 is derived from a measurement of the re-circulating Schottky

diode anode current. The re-circulating diode anode should be connected to the IS pin. The diode current flows

through an internal current sense resistor between the IS and PGND pins. The voltage level across the sense

resistor is sampled and held just prior to the onset of the next conduction interval of the buck switch. The diode

current sensing and sample & hold provide the DC level of the reconstructed current signal. The positive slope

inductor current ramp is emulated by an external capacitor connected from the RAMP pin to AGND and an

internal voltage controlled current source. The ramp current source that emulates the inductor current is a

function of the VIN and VOUT voltages per Equation 2:

IRAMP = (5 µ x (VIN – VOUT)) + 25 µA

(2)

Proper selection of the RAMP capacitor depends upon the selected value of the output inductor. The value of

CRAMP can be selected from:

CRAMP = L x 10

-5

where

•

L is the value of the output inductor in Henrys

(3)