PCM1792DB datasheet(28/62 Pages) TI2

28 / 62 page

PCM1792

SLES069B − MARCH 2003 − REVISED NOVEMBER 2006

www.ti.com

B15

B14

B13

B12

B11

B10

R/W

ATLD

FMT2

FMT1

FMT0

DMF1

DMF0

DME

MUTE

R/W: Read/Write Mode Select

When R/W = 0, a write operation is performed.

When R/W = 1, a read operation is performed.

Default value: 0

ATLD: Attenuation Load Control

This bit is available for read and write.

Default value: 0

ATLD = 0

Attenuation control disabled (default)

ATLD = 1

Attenuation control enabled

The ATLD bit is used to enable loading of the attenuation data contained in registers 16 and 17. When ATLD = 0,

the attenuation settings remain at the previously programmed levels, ignoring new data loaded from registers 16 and

17. When ATLD = 1, attenuation data written to registers 16 and 17 is loaded normally.

FMT[2:0]: Audio Interface Data Format

These bits are available for read and write.

Default value: 101

For the external digital filter interface mode (DFTH mode), this register is operated as shown in the Application for

Interfacing With an External Digital Filter section of this data sheet.

FMT[2:0]

Audio Data Format Selection

000

16-bit standard format, right-justified data

001

20-bit standard format, right-justified data

010

24-bit standard format, right-justified data

011

24-bit MSB-first, left-justified format data

100

16-bit I2S format data

101

24-bit I2S format data (default)

110

Reserved

111

Reserved

The FMT[2:0] bits are used to select the data format for the serial audio interface.

DMF[1:0]: Sampling Frequency Selection for the De-Emphasis Function

These bits are available for read and write.

Default value: 00

DMF[1:0]

De-Emphasis Sampling Frequency Selection

Disabled (default)

48 kHz

44.1 kHz

32 kHz

The DMF[1:0] bits are used to select the sampling frequency used by the digital de-emphasis function when it is

enabled by setting the DME bit. The de-emphasis curves are shown in the TYPICAL PERFORMANCE CURVES

section of this data sheet.

For the DSD mode, analog FIR filter performance can be selected using this register. Filter response plots are shown

in the TYPICAL PERFORMANCE CURVES section of this data sheet. A register map is shown in the Configuration

for the DSD Interface Mode section of this data sheet.

PCM1792DB bảng dữ liệu(PDF) 28 Page - Texas Instruments

PCM1792DB bảng dữ liệu(HTML) 28 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

bảng dữ liệu tải về

Link URL