L6740L datasheet(32/44 Pages) STMICROELECTRONICS

32 / 44 page

Output voltage monitoring and protections

L6740L

32/44

–

Permanently sets the PWM of the non-involved section to HiZ while keeping

ENDRV of the non-involved section low in order to realize an HiZ condition of the

non-involved section.

–

Drives the OSC/ FLT pin high.

–

Power supply or EN pin cycling is required to restart operations.

The OV threshold needs to be programmed through the OVP pin. Connecting the OVP pin

to SGND through a resistor ROVP, the OVP threshold becomes the voltage present at the

pin. Since the OVP pin sources a constant IOVP=11µA current, the programmed voltage

becomes:

Filter OVP pin with 100pF(max) to SGND.

7.2

Feedback disconnection

L6740L provides both CORE and NB sections with FB Disconnection protection. This fea-

ture acts in order to stop the device from regulating dangerous voltages in case the remote

sense connections are left floating. The protection is available for both the sections and

operates for both the positive and negative sense.

According to Figure 13, the protection works as follow:

●

CORE Section:

Positive sense is performed monitoring the CORE output voltage through both VSEN

and CS1-. As soon as CS1- is more than 600mV higher than VSEN, the device latches

with all PWMx set to HiZ and ENDRVx set to zero. FLT pin is driven high. A 30

µA pull-

down current on the VSEN forces the device to detect this fault condition.

Negative sense is performed monitoring the internal opamp used to recover the SGND

losses by comparing its output and the internal reference generated by the DAC. As

soon as the difference between the output and the input of this opamp is higher than

500mV, the device latches with all PWMx set to HiZ and ENDRVx set to zero. FLT pin is

driven high.

●

NB Section (SVI Only)

Positive sense is performed sourcing a 50

µA current that pulls-up the NB_VSEN pin in

order to force the device to detect an OV condition for the NB Section.

Negative sense is performed monitoring the internal opamp used to recover the SGND

losses by comparing its output and the internal reference generated by the DAC. As

soon as the difference between the output and the input of this opamp is higher than

500mV, the device latches with all PWMx set to HiZ and ENDRVx set to zero. FLT pin is

driven high.

To recover from a latch condition, cycle VCC or EN.

OVP

µA

⋅

OVP

µA

--------------------

L6740L bảng dữ liệu(PDF) 32 Page - STMicroelectronics

L6740L bảng dữ liệu(HTML) 32 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

bảng dữ liệu tải về

Link URL