TMP86FS49AIUG datasheet(95/296 Pages) TOSHIBA

tên linh kiện	TMP86FS49AIUG

Giải thích chi tiết về linh kiện	8 Bit Microcontroller

PDF	296 Pages

Scroll/Zoom	100%

nhà sản xuất	TOSHIBA [Toshiba Semiconductor]

Trang chủ	http://www.semicon.toshiba.co.jp/eng

Logo

95 / 296 page

Page 79

TMP86FS49AIUG

Note 4: Auto-capture can be used only in the timer, event counter, and window modes.

Note 5: To set the timer registers, the following relationship must be satisfied.

TC1DRA > TC1DRB > 1 (PPG output mode), TC1DRA > 1 (other modes)

Note 6: Set TFF1 to “0” in the mode except PPG output mode.

Note 7: Set TC1DRB after setting TC1M to the PPG output mode.

Note 8: When the STOP mode is entered, the start control (TC1S) is cleared to “00” automatically, and the timer stops. After the

STOP mode is exited, set the TC1S to use the timer counter again.

Note 9: Use the auto-capture function in the operative condition of TC1. A captured value may not be fixed if it's read after the

execution of the timer stop or auto-capture disable. Read the capture value in a capture enabled condition.

Note 10:Since the up-counter value is captured into TC1DRB by the source clock of up-counter after setting TC1CR<ACAP1> to

"1". Therefore, to read the captured value, wait at least one cycle of the internal source clock before reading TC1DRB for

the first time.

TMP86FS49AIUG bảng dữ liệu(PDF) 95 Page - Toshiba Semiconductor