TMP86CS64AFG datasheet(161/202 Pages) TOSHIBA

161 / 202 page

Page 151

TMP86CS64AFG

When an external clock is used, the data must be written to the data buffer register before shifting next data.

Thus, the transfer speed is determined by the maximum delay time from the generation of the interrupt request

to writing of the data to the data buffer register by the interrupt service program.

The transmission is ended by clearing SIO1CR1<SIOS> to “0” or setting SIO1CR1<SIOINH> to “1” in

buffer empty interrupt service program.

SIO1CR1<SIOS> is cleared, the operation will end after all bits of words are transmitted.

That the transmission has ended can be determined from the status of SIO1SR<SIOF> because

SIO1SR<SIOF> is cleared to “0” when a transfer is completed.

When SIO1CR1<SIOINH> is set, the transmission is immediately ended and SIO1SR<SIOF> is cleared to

“0”.

When an external clock is used, it is also necessary to clear SIO1CR1<SIOS> to “0” before shifting the next

data; If SIO1CR1<SIOS> is not cleared before shift out, dummy data will be transmitted and the operation will

end.

If it is necessary to change the number of words, SIO1CR1<SIOS> should be cleared to “0”, then

SIO1CR2<BUF> must be rewritten after confirming that SIO1SR<SIOF> has been cleared to “0”.

Figure 15-7 Transfer Mode (Example: 8bit, 1word transfer, Internal clock)

DBR

Clear SIOS

Write

(a)

Write

(b)

SCK1 pin

(Output)

SO1 pin

INTSIO1 interrupt

SIO1CR1<SIOS>

SIO1SR<SIOF>

SIO1SR<SEF>

TMP86CS64AFG bảng dữ liệu(PDF) 161 Page - Toshiba Semiconductor