STM32H562VG datasheet(55/270 Pages) STMICROELECTRONICS

55 / 270 page

DS14258 Rev 5

55/270

STM32H562xx and STM32H563xx

Functional overview

3.37.2

Low-power universal asynchronous receiver transmitter (LPUART)

The LPUART supports bidirectional asynchronous serial communication with minimum

power consumption. It also supports half-duplex single-wire communication and modem

operations (CTS/RTS). It allows multiprocessor communication.

Only a 32.768 kHz clock (LSE) is needed to allow LPUART communication up to

9600 baud. Therefore, even in Stop mode, the LPUART can wait for an incoming frame

while having an extremely low energy consumption. Higher-speed clock can be used to

reach higher baud-rates.

The LPUART interface can be served by the DMA controller.

The LPUART main features are:

•

Full-duplex asynchronous communications

•

NRZ standard format (mark/space)

•

Programmable baud rate

•

From 300 to 9600 bauds using a 32.768 kHz clock source

•

Higher baud rates can be achieved by using a higher frequency clock source

•

Two internal FIFOs to transmit and receive data

Each FIFO can be enabled/disabled by software and come with status flags for FIFOs

states.

•

Dual-clock domain with dedicated kernel clock for peripherals independent from PCLK

•

Programmable data word length (7 or 8 or 9 bits)

•

Programmable data order with MSB-first or LSB-first shifting

•

Configurable stop bits (1 or 2 stop bits)

•

Single-wire half-duplex communications

•

Continuous communications using DMA

•

Received/transmitted bytes are buffered in reserved SRAM using centralized DMA

•

Separate enable bits for transmitter and receiver

•

Separate signal polarity control for transmission and reception

•

Swappable Tx/Rx pin configuration

•

Hardware flow control for modem and RS-485 transceiver

•

Transfer detection flags:

–

Receive buffer full

–

Transmit buffer empty

–

Busy and end of transmission flags

•

Parity control:

–

Transmits parity bit

–

Checks parity of received data byte

•

Four error detection flags:

–

Overrun error

–

Noise detection

–

Frame error

–

Parity error

•

Interrupt sources with flags

STM32H562VG bảng dữ liệu(PDF) 55 Page - STMicroelectronics

STM32H562VG bảng dữ liệu(HTML) 55 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL