MPC8280 datasheet(468/1386 Pages) FREESCALE

468 / 1386 page

Memory Controller

MPC8280 PowerQUICC II Family Reference Manual, Rev. 1

11-48

Freescale Semiconductor

There are two levels of refresh request priority—low and high. The low priority request is generated as

soon as the refresh timer expires, this request is granted only if no other requests to the memory controller

are pending. If the request is not granted (memory controller is busy) and the refresh timer expires two

more times, the request becomes high priority and is served when the current memory controller operation

finishes.

NOTE

There are two SDRAM refresh timers, one for 60x SDRAM machines and

one for local bus SDRAM machines.

11.4.11 SDRAM Refresh Timing

The memory controller implements bank staggering for the auto refresh function. This reduces

instantaneous current consumption for memory refresh operations.

Once a refresh request is granted the memory controller begins issuing auto-refresh command to each

device associated with the refresh timer, in one clock intervals. After the last REFRESH command is issued,

the memory controller waits for the number of clocks written in the SDRAM machine’s mode register

(RFRC in P/LSDMR). The timing is shown in Figure 11-39.

Figure 11-39. SDRAM Bank-Staggered CBR Refresh Timing

11.4.12 SDRAM Configuration Examples

The following sections provide SDRAM configuration examples for page- and bank-based interleaving.

CLK

CS0

SDRAS

SDCAS

MA[0–11]

DQM

Data

CS1

CS2

CS3

RFRC

CBR

Activate

MPC8280 bảng dữ liệu(PDF) 468 Page - Freescale Semiconductor, Inc